• CNC-Pod for Beamicon2

Interface board for CNC control with up to 6 axes
(adapter from Ethernet to LPT port)


Brief product description



The interface board enables the operation of up to six stepper motor or servo output stages with the
Beamicon2 CNC software. A normal network connection with RJ45 cable is used for data transfer from the PC.
RJ45 cable is used for data transfer from the PC. The 25-pin SUBD connector can be connected to a conventional breakout board, the
TripleBeast or another controller with an LPT port, allowing up to 4 axes to be controlled.
axes can be controlled. A second port, which can optionally be connected to a pin connector with a ribbon cable
connector, additional inputs/outputs and signals for two further axes are available.
available.


As no parallel port is required on the PC, the familiar limitations of step frequency and timing problems are a thing of the past.
timing problems are a thing of the past. All signals are galvanically isolated from the PC, so that maximum
maximum interference immunity is achieved.

The CncPod is ideal if an existing controller that was previously operated with an LPT port is to be used for the
Beamicon2 software with network operation, or if the maximum of 4 axes of the
breakout board with integrated network interface (NETBOB1) is not sufficient.


Note: The software license for Beamicon2 is included in the price!



Manual

CNC-Pod for Beamicon2

  • 245.00€