Beamicon2 - Hardware

Beamicon2 - Hardware and modules

In this section you will find hardware that works together with the Beamicon2 control system.
You can use it to expand your existing system or set up a new control system.

Product Compare (0)

Sort By:

Show:

Beamicon2Basic and MDLCNC power amplifier from Letmathe (bundle)

Beamicon2Basic and MDLCNC power amplifier from Letmathe (bundle)Special offer!The MDLCNC-T4V6 steppe..

94.14€ 149.00€

Breakout-Board with LPT (for Micropod2-LPT)

The breakout board allows the operation of up to four stepper motor or servo output stages at the pa..

99.00€

CNC-Pod for Beamicon2

Interface board for CNC control with up to 6 axes(adapter from Ethernet to LPT port)Brief product de..

245.00€

FU-Modul (PWM to 0-10V and relay driver, galvanically isolated)

FU ModuleThis board can be used to convert a PWM signal into an analog signal of 0-10V. A relay can ..

21.00€

IO-Extension for Beamicon2

The IO extension provides additional digital inputs and outputs for the Beamicon2 CNC control system..

92.44€

Manual control unit for Beamicon2 CNC control with network connection

Manual control unit for Beamicon2 CNC control with network connectionThe hand-held control unit can ..

448.59€

Micropod2-LPT

The interface module allows the operation of up to four stepper motor or servo output stages with th..

23.00€

Netbob with Beamicon2 (Interface board for CNC control of up to 4 axes via Ethernet)

Netbob with Beamicon2Interface board for CNC control of up to 4 axes via EthernetBrief product descr..

289.84€

Netbob with Beamicon2 (interface board for CNC control of up to 6 axes via Ethernet)

Netbob with Beamicon2 (interface board for CNC control of up to 6 axes via Ethernet)Brief product de..

404.49€

Patch Panel RJ45

Patch Panel RJ45This small breakout board is used to conveniently connect a power supply cable to co..

19.00€

Showing 1 to 10 of 10 (1 Pages)